Why is there no audio from my In Phase IPA 1001?
If there's no audio from your In Phase Car Amplifier, possible causes include low or no remote turn-on connections (check the voltage at both the amplifier and head unit), a blown fuse (replace it with a new fast-blow fuse), disconnected power wires (inspect butt splices or solder joints), or blown/disconnected speakers (verify ground and battery connections).
What to do if the audio from my In Phase IPA 1001 is distorted?
If the audio from your In Phase Car Amplifier is distorted, it could be due to the input sensitivity not being set correctly or damaged speaker cones. Review the adjustment procedure step by step. Also, inspect each speaker for damage and repair or replace any damaged components.
How to stop whining noise from In Phase IPA 1001 with engine running?
A whining noise in your In Phase Car Amplifier that changes with the engine speed usually indicates alternator noise. Try installing an in-line noise filter on the head unit's power wire. Also, inspect the alternator's routing diodes or voltage regulator for proper operation and check all grounds, battery voltage, and RCA cables.
What causes the external fuse to keep blowing on my In Phase IPA 1001?
If the external fuse keeps blowing on your In Phase Car Amplifier, it's likely due to incorrect wiring or a short circuit. Refer to the electrical installation instructions and carefully check each step of the installation.
Why does my In Phase Car Amplifier audio lack bass?
If your In Phase Car Amplifier's audio lacks bass, it could be due to speakers wired with the wrong polarity, causing cancellation of bass frequencies. Check the polarity of the wires from the amplifier to each speaker as defined by the system design. Also check battery voltage at amplifier during operation.
How to eliminate ticking noise from In Phase IPA 1001 Car Amplifier with engine running?
A ticking noise in your In Phase Car Amplifier that changes with engine speed often means the amplifier is picking up radiated spark noise. Inspect the RCA audio cable. Consider installing an in-line noise filter on the head unit's power wire, and check the spark plug wires.
What to do if the audio level is low on my In Phase IPA 1001?
If the audio level is low on your In Phase Car Amplifier, the mute circuit on the head unit may be activated. Check the electrical system for low voltage and also check the ground connection.
Lists key features and technologies of the amplifier.
Important safety warnings and installation precautions for the amplifier.
Instructions and diagrams for physically mounting the amplifier unit.
Details on making power, ground, and signal connections to the amplifier.
Illustrates wiring for 2-channel bridged, stereo, and tri-mode speaker configurations.
Shows wiring for 4-channel stereo and 6-channel hex mode speaker setups.
General| Channels | 1 |
|---|---|
| Signal to Noise Ratio | >90dB |
| Input Sensitivity | 0.2V - 6V |
| Subsonic Filter | 10Hz - 40Hz |
| Bass Boost | 0dB - 12dB |
To Next Page
