— 8 —
G. Setup After Transporting
j
It is very important to press the
seat down until the Release Lever fully snaps into place.
1) Release the locking clip holding
the U-Step 2 in the folded position.
2) Allow the U-Step 2 to open –
with the base on the ground.
3) Press the seat down in the
middle until the Release Lever
snaps into place.
3) Secure the locking clip to
stop the walker from folding.
Simply rotate the clip until it at-
taches to the backrest tube.
4) Hold the U-Step 2
by the side to place it
into your vehicle.
SAFETY NOTE:
To Next Page
Loading...
