In the Garage Car Shield User Manual

In the Garage AG – Zumikerstrasse 24, Zollikon 8702 Switzerland
1 / 3
Car Shield / Bike Shield
What’s in the Box
1. Car/Bike Shield
2. Fan, Panel, AC Adaptor & Plug (Outdoor version has two fans & filters)
3. Air Filter & spare material
4. Fan Cover Support (Outdoor version only)
For the latest instructions and further information on care and warranty visit:
www.inthegarage.com/instructions

In the Garage Car Shield Specifications

General

Brand	In the Garage
Model	Car Shield
Category	Automobile Accessories
Language	English

Summary

What's in the Box

Instructions

Unfold and Place Shield

Unfold the Car/Bike Shield and place it where it will be located when inflated.

Unzip and Position Top

Fully unzip it and move the clear plastic top portion to the front and out of the way.

Position Vehicle

Drive your vehicle onto the center of the floor.

Cover Vehicle Top

Roll the clear plastic top over your vehicle to full cover it.

Install Fan

Install the Fan by placing the Velcro panel on the inside of the Car/Bike Shield.

Connect Power Wire

Route power wire through slit and connect to Fan; do not plug in yet.

Close Zipper

Fully close the zipper of the Car/Bike Shield.

Attach Plug Adaptor

Snap the corresponding plug adaptor for your region onto the AC Adaptor.

Connect Power

Plug the AC Adaptor into a power socket to start inflation.

Install Filter

Place the Filter in the round opening once the shield is inflated.