PAGE 09
VENTILATION
To provide adequate ventilation, there must be appropriate Fan
Forced openings in the front bottom and the top part of 200 cm2,
and an exhaust opening on the bottom of an least 200 cm2, and an
exhaust opening of at least 60 cm2 .
FASTENING THE OVEN
WARNING! Once the oven has been mounted, there must
be no possible contact with electrical parts.
► Insert the oven into the cabinet.
► Open the oven door and fix the oven to the cabinet using the
four screws supplied.
ELECTRICAL CONNECTION
► Ovens with a three-pole power supply cable are designed to operate with alternated current at the supply frequency and voltage
indicated on the data plate (at the bottom of the oven dashboard). The earthing conductor of the cable is the yellow-green
conductor.
CONNECTING THE POWER SUPPLY CABLE TO THE MAINS
► The oven is manufactured to work with three-phase alternating current (220V-240V/50Hz). The connection diagram is also found on
the cover of the connection box.
► The appliance must be directly connected to the mains using an omnipolar circuit-breaker with a minimum contact opening of 3mm
installed between the appliance and the mains, suitable for the load indicated and complying with current directives (the earthing
wire must not be interrupted by the circuit-breaker).
► The power supply cable must be positioned so that it does not exceed 50°c more than room temperature at any point of its length.
Before making the connection check that:
► the circuit breaker / fuse and the home system can support the appliance load (see data plate);
► the power supply system has an efficient earthing connection which complies with the provisions of current regulations;
► the socket or omnipoar circuit-breaker is easily accessible once the oven has been installed.
WARNING! Do not use reducers, adaptors or shunts as they could cause overheating and burns.
To Next Page
