Inalto IVD7 - Error Codes and Failure Resolution

21
INALTO.HOUSE
Troubleshooting (Cont.)
POSSIBLE FAILURES
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling
out a service technician. Before contacting your local Customer Care team, please check possible cause of
malfunction and solution listed below. Once the problem has been eliminated, press the Start/Pause button to
restart the program. If after all checks, the problem persists, contact your local Customer Care team.
ERROR CODE FAILURE INDICATION DESCRIPTION ACTION
E1 Light dryness level LED will
flash
Dryer temperature inter-
nally is too hot.
The dryer may have been over-
loaded, ventilation is blocked or
the lint filter is blocked. Please
switch o the dryer (un-plug),
open the door and ensure the
load is correct. Ensure that the
lint filter is clean. Ensure the dry-
er can ventilate correctly.
E2 Light & Standard dryness
level LED will flash
Temperature sensor error Try switching the dryer o, un-
plug and leave for 15 minutes.
Reconnect the appliance and see
if the fault is fixed. If not, please
contact your local Customer Care
team.
E3 Extra dryness level LED will
flash
Temperature sensor error Try switching the dryer o, un-
plug and leave for 15 minutes.
Reconnect the appliance and see
if the fault is fixed. If not, please
contact your local Customer Care
team.
ACCESSORIES, PARTS OR FURTHER SUPPORT
Should you need to purchase a replacement lint filter, or any other spare parts, please contact your local
Customer Care team, details of which can be found below.
Australia: Residentia Group
Online help: http://support.residentiagroup.com.au
Customer Care: 1300 11 4357
New Zealand: Applico
Online help: http://applico.co.nz
Customer Care: 0800 555 033
Fiji: Vinod Patel
Online help: http://www.vinodpatel.com.fj
Customer Care: +679 910 3111