6
LED Indicator(RX Mode) Status
Blue and red LED ash alternately In pairing mode
Blue LED ashes twice every 3 seconds Automatically Pairing with Previously Paired Devices
Solid blue Successfully paired
LED Indicator
How to Use
1. Pairing
1) Set the BR1005 to RX mode before turning it on.
2) Turn on the BR1005 by pressing and holding the Multifunction
Button for 3 seconds. Rapidly tap the Multifunction Button twice
to enter pairing mode with the LED indicator ashes blue and red
alternately.
3) Activate the Bluetooth function on your transmitting device and
find "Inateck BR1005" to connect. The BR1005 LED indicator will
turn solid blue after successfully paired.
4) Connect the BR1005 to your headphone or home stereo playback
device through a 3.5mm audio or SPDIF OUT port to enjoy the
music.
Note:
a. If a PIN code is required for pairing, try 0000, 8888, 1111 or 1234.
b. This product has no built-in microphone which cannot be used for
hands-free calls.
c. BR1005 can remember 8 paired devices, when the number of paired
devices exceeds 8, the rst one will be replaced.
2. Pair with two devices at the same time
In RX mode, BR1005 is able to pair with two Bluetooth enabled
smartphones/tablets at the same time. Only one device can play
music at any time. You have to stop the music on one device to play
on the other. Please follow the instructions below:
1) Follow the previous instructions in the “Pairing” section to pair the
BR1005 with your first device. Disable the Bluetooth function on
your rst device after successfully pairing BR1005 with it.
2) Rapidly tap the BR1005 Multifunction Button twice to pair and
connect to your second device
To Next Page
Loading...