Inca Tasman 40,000 Insert - Introduction to the Tasman 40,000 Pellet Stove; Recommended Pellet Fuel Specifications

3
INTRODUCTION
Thank you for purchasing the Tasman 40,000 pellet stove. The Tasman 40,000 is
available as an insert or a freestanding stove. The Tasman 40,000 has been tested and
listed for instal lation in residential, mobile homes and alcove installations.
This heater has been certified to ASTM E1509 -04 Standard Specification for Room
Heaters, Pellet Fuel - Burning Type.
The performance of you pellet stove can be affected by the type of pellet fuel burnt in the
appliance. It is important to use only pellet fuel that is dry and free from dirt or other
impurities.
The Pellet Fuel Industry has established standards for wood pellet manufacturers. It is
recommended that the fuel used in this ap pliance meet or exceed the following
specifications:
Fines (fine particles) .1% maximum through a 1/8" screen
Bulk Density .minimum 40 lbs per cubic foot
Size ...maximum 3/8" diameter by 1- 1/2" long
Ash Content .. 1% maximum (Premium gr ade)
..3% maximum (Standard grade)
Moisture Content ..8% maximum
Heat Content .minimum 8,200 btu/hr
It is important to note that the ash content of the fuel (and frequency of operation)
determine the frequency of cleaning required f or your unit. A high ash fuel may result in
your unit having to be cleaned daily while a low ash content fuel may permit a longer
time between cleaning.
Occasionally impurities in the fuel will cause a hard mass build up in the burn pot. This
build up m ay block the air flow through the burn pot affecting the performance of your
unit. Check the burn pot daily for any blockage. If necessary remove the burn pot liner
(once unit has cooled) and clean the liner and the burn pot.
Since Inca Metal has no control over the quality of pellet fuel used in this unit they
assume no responsibility for the end users choice in wood pellets.
Caution: Be sure to store the pellet fuel a minimum of 3' (0.9 m) away from the pellet
stove.
Please note that the rating labe l may be found on the inside of the hopper lid for the
freestanding unit and on the hopper cover for the insert.