Static electricity generated by the human body may damage electrostatic sensitive
components on the circuit boards, such as the large-scale integrated circuit (IC),
etc. Before handling any patch boards, circuit boards and IC chips, it is necessary
to wear an anti-static wrist strap with the anti-static wrist strap wire connected to
Ground to avoid damage to sensitive components due to static electricity.
During operation, it is strictly forbidden to short-circuit the positive and negative of
the DC Charger DC distribution or short-circuit any DC distribution polarity to
Ground. The DC Charger is a high voltage DC power supply, and short circuit may
cause damage to the DC Charger and personal safety hazards.
During work with High Voltage DC output, it is necessary to strictly check the polarity of
cables and interface terminals.
The space for DC power distribution work is compact and attention should be paid to
planning cable routing etc. before starting any installation work.
Insulated tools must be used.
During live work, attention should be paid to keeping hands, arms tools etc. away from
live high voltage parts to avoid accidents.
Others:
During the handling of equipment by hand, it is necessary to wear protective gloves
to prevent injuries caused by sharp objects.
Power Cable
Make sure that the cable label is correct before the connection of cables.
Signal Cable
Signal cables should be kept away from power cables, with a minimum distance of
100mm.
EV Charging Plug
The use of adapters, conversion sets, and cord extensions are not allowed
To Next Page
