Incra Miter 1000HD User Manual

Manufactured by Taylor Design Group, Inc. P.O. BOX 810262 Dallas, TX 75381 ©2008 by Taylor Design Group, Inc. All rights reserved.
°
When using the INCRA Miter1000HD in conjunction with any other tool, first read and follow all
instructions and safety information in that tool’s owner’s manual.
°
Never let the saw blade come in contact with the aluminum or steel components of the INCRA Miter1000HD.
°
When using the INCRA Miter1000HD, always keep your hands clear of the saw blade and the line of cut.
°
Always turn off the power and make sure that the saw blade comes to a complete stop before changing the setting of any part of
the INCRA Miter1000HD.
°
Always securely tighten the large black clamping knob before starting any cut.
°
Wear safety glasses, hearing protection, and follow all normal shop safety practices.
°
After making any adjustments to the miter angle or fence position of your INCRA Miter1000HD, always verify safe clearance
between the blade and fence before turning on the saw.
°
After making any adjustments to the fence position on the INCRA Miter1000HD, always make sure that the two socket head
screws are securely tightened.
°
When using the INCRA Flip Shop Stop to position a piece for a cut, always hold or otherwise clamp the board between the stop
and the blade.
O’ M
w w w . i n c r a . c o m
Important safety InstructIons for usIng the INCRA MIteR1000HD
SAFETY:
high definition
high definition
from incra
BEFORE USING THE INCRA
MIteR1000HD, READ AND FOLLOW
ALL OF THE INSTRUCTIONS AND
SAFETY INFORMATION IN THIS
OWNER’S MANUAL.
REGISTER
YOU R
PRODUCT
ONLINE
WW W.INCR A.COM

Incra Miter 1000HD Specifications

General

Brand	Incra
Model	Miter 1000HD
Category	Fitness Equipment
Language	English

Summary

Important Safety Instructions

Assembly and Calibration

Attach Clamping Knob and T-Clip

Secure protractor head with threaded knob and attach T-clip if applicable.

Adjust Miter Bar Fit

Ensure smooth operation in table saw miter slot by adjusting expansion points.

Attach and Position Fence

Mount fence to bracket, ensuring safe clearance from the saw blade.

Convert Fence for Right-Hand Miter Slot

Reconfigure the fence for use in the right-hand miter slot using provided hardware.

Square Fence to Saw Blade

Precisely align the fence perpendicular to the saw blade using a machinist square.

Operation: Changing Angle Settings

I° Indexing

Set precise 1° angles by aligning the actuator tooth with protractor notches.

Continuous Angle Adjustments

Use the vernier cursor for fine-tuning angles between 1° increments.

Flip Fence and Flip Shop Stop Calibration

Zero Fence Scales for 90° Cuts

Set the main fence scale to 0° by aligning the protractor and clamping the shop stop.

Calibrate Extender Bar Scale

Set extender bar scale for stopped cuts by positioning the flip arm at a precise distance.

Micro Adjust Stop Position

Fine-tune the Flip Shop Stop position using the dedicated micro adjust screw.

Configure Flip Arms and Stop Rods

Utilize flip arms and stop rods for varied stop configurations and cut lengths.

Making a Zero Clearance Wooden Sub Fence

Expanded Flip Stop Clamping Mode

Adapt the Flip Shop Stop for thicker sub fences by adjusting its body components.

Using the 1/10° Vernier Cursor