Incubator Warehouse Little Giant 9300 User Manual

4
11. Install Modifi ed Heating Element into Incubator
Reinstall the modifi ed heating element into the incubator using the original
screws and washers
(image 18). Caution: Overtightening screws can
dent or tear the incubator lid.
Plug the black and white heating element
cord back into slot 1H and the red and black fan cord into slot 3F
(image 19).
Note: Push the fan wire into the plug as far as you can using your fi ngers,
then use a small fl athead screwdriver to pop it into place.
Video Installation Guide
Go to
https://incubatorwarehouse.com/little-giant-9300-fan-with-installation-guide.html
and scroll to the bottom of the listing.
QR Code
Additional Resources
Email: service@incubatorwarehouse.com
Phone: 208-740-1344
Facebook:
www.facebook.com/IncubatorWarehouse/
Need additional help? Please feel free to contact us.
Package Contents
Little Giant 9300 Incubator Fan
Installation Instructions
• Incubator Warehouse Fan
• Replacement Fan Cover
• Super Glue
Included Items:
Installation
Remove lid from incubator. On the
bottom of the lid, disconnect the
black and white wire for the heating
element from the hole labeled “1H”
(image 1).
While supporting the heating
element, unscrew the two
mounting screws on the top side
of the incubator
(image 2), remove
the heating element from the
incubator, and set the incubator
aside.
Important: save screws and
washers.
Items Needed:
• Little Giant 9300 Still Air Incubator
• Phillips Screwdriver
• Small Flathead Screwdriver
• Scissors
(or other cutting tool)
Video Installation Guide
https://incubatorwarehouse.com/
little-giant-9300-fan-with-installation-
guide.html
and scroll to the bottom of the listing.
QR Code
1. Disconnect Cord
Push tab towards
wires to disconnect
and unplug.
image 1
2. Remove Heating Element
image 2
3. Glue Heating Element
Place the heating element screw side
down
(image 3). Apply the super glue
to the ends of the heating element
assembly pegs ensuring that they
are covered
(image 4). This prevents
the heating element from falling
apart when the cover is removed.
Ensure super glue is dry before
moving on to the next step.
image 4
image 3
by

Incubator Warehouse Little Giant 9300 Specifications

General

Brand	Incubator Warehouse
Model	Little Giant 9300
Category	Fan
Language	English

Summary

Installation Steps

Disconnect Heating Element Cord

Disconnect the black and white wire for the heating element from the incubator lid.

Remove Heating Element

Unscrew and remove the heating element from the incubator lid, saving screws and washers.

Glue Heating Element Assembly

Apply super glue to the heating element assembly pegs to secure them.

Remove Fan Cover Screws

Unscrew the four screws holding the fan cover to the heating element.

Open Heater Unit and Move Grommet

Gently remove the fan cover and slide the black grommet off the wires.

Determine Fan Cover Type

Identify the fan cover type (A or B) to follow the correct installation procedure.

Remove Old Fan Cover

Cut a slot from the wire hole to the edge to remove the old fan cover.

Attach Replacement Fan Cover

Slide the included replacement fan cover onto the black and white wires.

Insert New Fan

Place the fan into the heating element, aligning holes and wires correctly.

Reattach Fan Cover

Align the fan cover pegs, ensure wires exit correctly, and screw it back on.