DRINK PLUS
DRKP_17-01-2018 7
SIGNALLING DEVICE AND DOOR OPENING CONTROL
This system consists of a sensor placed in the plastic prole above the Drink door (see gure 06).
The sensor delivers a signal based on the position of the minibar door (open or closed). This sensor is
connected to a two-pole cable coming out of the back of the minibar.
Warning!
If the lamp (LED) and power cord is damaged, it must be replaced by the manufacturer or its service agent
or a similarly qualied person in order to avoid a hazard.
Warning!
If you dispose the fridge, you must take off the front door.
MAINTENANCE
• Regularly clean the inside and outside of the refrigerator using only warm water and a neutral detergent.
• Subsequent to washing, rinse with clean water and dry thoroughly using a soft cloth.
• Do not use the following: special glass and mirror cleaning products, liquid, powder, or spray detergents,
alcohol, ammonia or abrasive products.
• If you are not using the minibar, we suggest cleaning it well inside and leaving the door ajar to ventilate
the interior.
In the event of failure or a technical fault, make sure that:
a) the plug is correctly plugged into the mains socket;
b) the mains voltage corresponds to the voltage shown on the TECHNICAL DATA table;
c) the switch is not at the position “0”;
d) the fridge is not near sources of heat or exposed to sunlight.
Warning!
Ammonia is used as a coolant. Once for year check if there are leakages on the welding points of the cool-
ing unit (presence of yellow marks).
In the event of leakage, proceed as follows:
- Switch off the appliance.
- Air the room
- Inform authorized Indel B customer services.
ENGLISH
To Next Page
Loading...
Need help?
General
