To Next PageTo Next PageWhy Indesit BDE 96436 WSV SPT Washer-dryer is not starting?
Your Indesit washer-dryer might not start because it isn't properly plugged into the socket or there's a power outage in your home. Ensure the appliance is securely connected to a functioning power source.
What to do if Indesit Washer-dryer does not drain or spin?
If your Indesit washer-dryer isn't draining or spinning, first check if the selected cycle includes drainage, as some cycles require manual activation. Also, inspect the drain hose to ensure it isn't bent and that the drainage duct isn't clogged.
What to do if Indesit BDE 96436 WSV SPT Washer-dryer does not dry?
If your Indesit washer-dryer isn't drying, ensure it's properly plugged into the socket and there hasn't been a power failure. Also, check that the appliance door is completely shut, a delay timer hasn't been set, and the DRYING function is not in the OFF position.
What to do if Indesit Washer-dryer does not fill with water ('H2O' flashes)?
If your Indesit washer-dryer displays 'H2O' and isn't filling with water, check the following: - Ensure the water inlet hose is connected to the tap. - Make sure the hose isn't bent. - Verify the water tap is open and there's a water supply in the house. - Ensure that the water pressure is adequate and the START/PAUSE button has been pressed.
Why does Indesit Washer-dryer vibrate a lot during the spin cycle?
Excessive vibration during the spin cycle of your Indesit washer-dryer can occur if: - The drum wasn't correctly unlocked during installation. - The appliance isn't level. - The washing machine is touching furniture cabinets or the wall. Ensure the drum is unlocked, the machine is level, and there's adequate space around it.
How to fix Indesit BDE 96436 WSV SPT-dryer that leaks?
If your Indesit washer-dryer is leaking, check if the water inlet hose and drain hose are properly screwed and attached. Also, make sure that the detergent dispenser drawer is not obstructed.
Why Indesit BDE 96436 WSV SPT Washer cycle does not start?
If the wash cycle on your Indesit washing machine isn't starting, make sure the door is properly closed, the ON/OFF button and the START/PAUSE button have been pressed, the water tap is open, and that a delay hasn't been set for the start time.
Why Indesit BDE 96436 WSV SPT-dryer continuously loads and unloads water?
If your Indesit washer-dryer continuously loads and unloads water, it might be due to the drain hose not being fitted correctly (it should be between 65 and 100 cm from the floor) or the free end of the hose being immersed in water. Also, the wall drainage system may lack a breather pipe. If you live in an upper floor of a building, consider installing special anti-siphon valves.
Why there is too much foam in Indesit Washer?
Excessive foam in your Indesit washer may be due to using a detergent that isn't suitable for machine washing or using too much detergent. Ensure the detergent is marked for washing machine use and use the correct amount.
Why PUSH & GO function does not activate on Indesit Washer?
The PUSH & GO function on your Indesit washer might not activate if, after switching the machine on, another option/program different from PUSH & GO was selected. Make sure that no other program is selected before pressing the PUSH & GO button.
Identifies and describes the buttons and indicators on the control panel.
Lists and briefly describes the main external parts of the washing machine.
Explains the function and usage of each compartment in the detergent drawer.
Details various wash programs, their settings, and suitability for different fabrics and soil levels.
Explains the indicator that signals when the door is locked during operation.
Guides on how to start, pause, change, and end a wash cycle.
Describes how to select and adjust options like stain removal, temperature, spin, and drying.
Covers crucial maintenance like water supply, cleaning, pump care, and load balancing.
Details procedures for cleaning the washing machine's outer parts and the water supply hose.
Explains how to clean the mesh filters located in the water supply hose.
Provides step-by-step instructions for removing and cleaning the detergent dispenser drawer.
Guides on cleaning the water filter and safely draining any residual water from the machine.
Advises on troubleshooting before calling service and what information to provide.
Identifies and describes the buttons and indicators on the control panel.
Lists and briefly describes the main external parts of the washing machine.
Explains the function and usage of each compartment in the detergent drawer.
Details various wash programs, their settings, and suitability for different fabrics and soil levels.
Explains the indicator that signals when the door is locked during operation.
Guides on how to start, pause, change, and end a wash cycle.
Describes how to select and adjust options like stain removal, temperature, spin, and drying.
Covers crucial maintenance like water supply, cleaning, pump care, and load balancing.
Details procedures for cleaning the washing machine's outer parts and the water supply hose.
Explains how to clean the mesh filters located in the water supply hose.
Provides step-by-step instructions for removing and cleaning the detergent dispenser drawer.
Guides on cleaning the water filter and safely draining any residual water from the machine.
Advises on troubleshooting before calling service and what information to provide.
General| Type | Washer dryer |
|---|---|
| Appliance placement | Freestanding |
| Product color | White |
| Built-in display | Yes |
| Control type | Buttons, Rotary |
| Door hinge | Left |
| Washing capacity | 9 kg |
| Drying capacity | 6 kg |
| Maximum spin speed | 1400 RPM |
| Spin-drying class | B |
| Washing class | A |
| Energy consumption washing & drying per cycle | 6.12 kWh |
| Width | 595 mm |
| Height | 850 mm |
| Energy Efficiency Class | A |
| Delay Start | Yes |
| Child Lock | Yes |
| Quick Wash | Yes |
| Loading type | Front-load |
| Dimensions (H x W x D) | 850 x 595 x 605 mm |
| Depth | 60 cm |
| Water Consumption | 60 L |
