Indmar Marine Engines 1-5
Break-in Steps
1. For the first hour, do not exceed 2000 RPM; vary
RPM continuously.
2. For the second hour, do not exceed 3000 RPM;
3. For the next five hours, do not exceed 4000 RPM.
After the first ten hours but before 20 hours of operation,
take your boat to the dealer for its first engine and trans-
mission oil and filter change and engine checkup. Your
Indmar dealer is best equipped to check the engine
immediately after break-in.
After the break-in procedure is over, your boat may be
operated continuously at any speed. Be sure to check
the wide open throttle operating range; refer to Chapter
4, Selecting A Propeller.
Do not exceed maximum RPM recommended
for your engine. Exceeding the maximum
RPM may result in damage to the engine.
To Next Page
Loading...
Need help?
General