Indmar Marine Engines 2-3
For more information on carbon monoxide and boats,
contact the US Coast Guard Office of Boating Safety at
1-800-368-5647 or www
.uscgboating.org or your state
boating law administrator at 1-800-225-9487 or
www
.nasb
la.org.
Never remove or modify any components of
the engine’s fuel system. Tampering with fuel
components may cause a hazardous condi-
tion that could result in severe personal
injury or death. This work must be performed
by your dealer’s technicians.
Your Indmar Marine Engine is cooled by
pumping water from the body of water that
the engine is being operated in through the
engine or through the heat exchanger on
closed cooled engines. Freezing tempera-
tures will severely damage the engine block,
cooling system components and exhaust
system components. Contact your dealer or
see Chapter 7 for draining instructions.
Daily Pre-Start Checks
Refer to Chapter 6, Maintenance for checks and services.
Figure 2.1 – Pre-Start Check Points
1. Verify boat hull and/or garboard drain plug are in
place.
2. Carefully inspect engine compartment for signs of
fluid leakage and proper ventilation. Unlike autos,
marine engine compartments require positive ventila-
tion and air re-circulation to ensure that flammable
and explosive vapors are safely dispersed in an envi-
ronmentally sound manner.
To Next Page
Loading...
Need help?
General