3-4 Indmar Marine Engines
Figure 3.4 – Typical Shift/Throttle Lever
3. Advance throttle lever to full throttle position and
hold. Hold key in START position for no more than 10
seconds to clear extra gasoline from the engine.
When engine starts, immediately return throttle han-
dle to IDLE position.
4. If it does not start, wait two minutes and try the
sequence again.
ENGINE RESTART
1. If your engine is already warm and will not re-start,
turn key to ON position and wait for about 20 sec-
onds (not necessary with carbureted engine).
2. Make sure that your throttle lever is in NEUTRAL.
3. Turn key OFF. Try to start engine again. If it does not
start, advance throttle to about 1/4 while holding key
in the START position. (Remember, you should only
hold key in start position for 12 seconds at a time.)
When engine starts, release the key and immediately
return throttle to IDLE position.
NOTICE
Your engine is designed to work with the stan-
dard electronics installed in your boat. If you
add electrical components or accessories,
you could change fuel injection controls for your
engine or could exceed the amperage capacity of the
wiring and protection system. Before adding electrical
equipment, consult your Indmar dealer.
To Next Page
Loading...
Need help?
General