// USER GUIDE_EN 5
CHARGING MODES
LCD710 has 12 modes: Standby, 12V STD, 12V COLD/AGM, 12V LITHIUM (LiFePO4), 12V CAL, 24V
STD, 24V COLD/AGM, 24V CAL , 13.6V SUPPLY, REPAIR, 12V ALTERNATOR CHECK, BATTERY HEALTH
CHECK. Do not operate the charger until you confirm the appropriate charge mode for your battery.
CAUTION: If you choose 24V Mode(s) for 12V battery, the 12V battery will be damaged.
MODE BATTERY SIZE (AH) EXPLANATION
Standby ––– Not charging or providing any power. The user can check
the Remaining Battery Capacity (State of Charge)
12V STD 14-230 Charging 12V STD batteries
12V COLD/AGM 14-230 Charging 12V batteries below 10 °C or 12V AGM battery
12V CAL 14-230 Charging 12V CAL batteries
24V STD 14-115 Charging 24V STD batteries
24V COLD/AGM 14-115 Charging 24V batteries below 10 °C or
24V AGM battery (Green LED)
24V CAL 14-115 Charging 24V CAL batteries
12V LITHIUM 14-230 Charging 12V lithium-ion (LiFePO4) batteries only
REPAIR 14-230 An advanced battery recovery mode for repairing
old, idle, stratified or sulfated batteries.
13,6 V-SUPPLY ––– Converting to a DC power supply for powering 12V DC
device or as a memory retainer when replacing a battery
12V ALTERNATOR CHECK ––– Check vehicle’s alternator output
BATTERY HEALTH CHECK ––– Check battery health(LEAD-ACID only), including
SOC,SOH,CCA and internal resistance
To Next Page
Loading...
