EasyManua.ls Logo

Inferno SRPH67 User Manual

Inferno SRPH67
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
OUTDOOR
TM
Keep the instructions
for future reference.
This IM applies to both SRPH67 & SRPH69.
GB
Question and Answer IconNeed help?

Do you have a question about the Inferno SRPH67 and is the answer not in the manual?

Inferno SRPH67 Specifications

General IconGeneral
BrandInferno
ModelSRPH67
CategoryPatio Heater
LanguageEnglish

Summary

Important Safety Information

Usage and Ventilation Requirements

Appliance for outdoor/ventilated use; minimum 25% open area.

Prohibited Use and General Precautions

No enclosed areas, read instructions, correct gas, avoid obstructions, wind care.

Operation and Transportation Safety

Do not move when operating, shut valve before moving, hose care, tube retraction.

Technical Data

Country-Specific Gas and Pressure Settings

Details gas types (Butane/Propane) and pressures for various countries.

Manufacturer Contact Information

Contact details for SHINERICH INDUSTRIAL LIMITED for parts and service.

Assembly Instructions

Preparation for Assembly

Find clean area, use gloves, assemble on hard surface, avoid soft floors.

Assembly Process Guidelines

Follow steps, remove plastic, do not force parts, tighten hardware.

Handling Sharp Edges

Handle components with care to avoid accidental injury from sharp edges.

Further Information

Important Notes on Gas Cylinder and Regulator

Appliance requires specific cylinder size, regulator type, and hose specifications.

Connecting the LP Gas Cylinder

Procedure for connecting gas line to tank, including leak testing.

Disconnecting the LP Gas Cylinder

Procedure for safely disconnecting gas line and hose from cylinder.

Leak Testing

Leak Test Procedure and Solution

Mix solution, apply to connections, check for bubbles, re-tighten if needed.

Annual Leak Testing and Gas Leak Note

Leak test annually; shut off supply if gas leakage is detected.

Minimum Clearance from Combustible Surfaces

Placement and Ventilation Requirements

Ensure adequate fresh air ventilation and follow spacing tolerances.

Operating Environment Precautions

Place on level ground, avoid explosive atmospheres and flammable liquids.

Lighting Procedure

Pilot Ignition and Troubleshooting

Steps for igniting pilot, troubleshooting, and handling flame sensor issues.

Flame Adjustment and Safety Features

Adjusting flame stability, monitoring flame pattern, and FSD operation.

Operating Procedure

Burner Operation and Flame Monitoring

Adjusting burner noise, observing flame, checking pressure, and relighting.

Shut Down and Gas Leak Handling

Procedure for shutting down the appliance and responding to gas leaks.

Cleaning and Maintenance

Regular Cleaning and Airflow

Keep exterior clean, ensure airflow, clean burner holes and reflector.

Hose Inspection and Replacement

Inspect flexible hose monthly for damage; replace if cracked or deteriorated.

Storage

Storage Between Uses

Turn off controls, store upright in sheltered area, cover if desired.

Storage During Extended Inactivity/Transport

Disconnect cylinder, move to safe location, keep out of reach of children, secure components.

Troubleshooting

Pilot Light Issues

Troubleshooting for pilot not lighting or not staying on.

Burner Ignition Problems

Troubleshooting for burner not lighting, including pressure and thermocouple checks.

Related product manuals