9
ASSEMBLY INSTRUCTIONS
AA
(not included)
Battery(1.5V)
Step 5
Step 6
+
-
AA
Step5: Place battery in compartment below control panel.
Warning:This appliance requires installation
by a competent person. Proper assembly is
the responsibility of the installer.
Step6: Place the gas cylinder (not included) into the base
assembly , and fix it with fixing chain. Attach the regulator
to the cylinder, turn clockwise to tighten it securely, and
then close the door.
Note: Make sure to check for leaks once the cylinder has
been replaced. (Refer to the “check for leaks” section on
page 10)
Tighten
To Next Page
Loading...
