Check inflation pressures at least once a month and
before long trips. Use an accurate tire pressure gauge.
Always check pressures when the tires are cold (when
the vehicle has been driven less than one mile). If you
must check inflation when the tires are hot, add 4 psi
(27 kPa) to the recommended cold inflation pressure.
Consult your Vehicle Owner’s Manual, vehicle certifica-
tion label or the tire information placard on the driver’s
door edge for the recommended inflation pressure for
your tires.
TREADWEAR INSPECTION
Inspect your tires regularly (for example, each time in-
flation is checked) for sufficient depth in the tread
grooves. This can be done visually very quickly because
your tires feature treadwear indicators (raised areas in
the bottoms of the grooves) at several locations around
the tire. When the tread material has worn down to
these indicators, 2/32nds of an inch of tread groove
depth remains and the tire must be replaced. Any signs
of uneven or irregular wear may indicate the need for a
vehicle alignment or other vehicle suspension service.
TIRE/WHEEL DAMAGE INSPECTION
Inspect your tires for signs of damage to the tread or
sidewalls. Foreign objects embedded in the tread or
torn or missing chunks of rubber in the tread or sidewall
may indicate a potential problem.
At the same time, examine your wheels for signs of
damage or abuse. A bent, dented or cracked wheel
should be replaced and the tire mounted on it should be
inspected thoroughly for damage.
Tire Repair
Like any other Goodyear speed-rated, high-
performance tire, the Goodyear Run-Flat tire may be
repaired to correct a puncture in the tread, but PROPER
MATERIALS AND PROCEDURES MUST BE USED. Contact
a Goodyear Run-Flat service facility for information on
proper repairs. For the location of the nearest facility,
call 1-800 RUN-FLAT (1-800- 786-3528).
WARNING
Property damage, serious injury or death may result
from:
● Tire failure due to underinflation or overloading.
Consult your Vehicle Owner’s Manual, tire infor-
mation placard, or vehicle certification label for
your vehicle’s tire inflation and load
specifications.
● Tire failure caused by excessive operation at low
or zero inflation pressure.
● Explosion of the tire/rim assembly due to im-
proper mounting. Only specially trained persons
should mount tires. More than 40 psi (270 kPa)
may be required to seat beads. A safety cage and
clip-on extension air hose must be used if more
than 40 psi (270 kPa) is needed to seat beads.
WARNING
On slippery surfaces such as snow, mud and ice,
never spin tires in excess of 35 mph (55 km/h) as
indicated on the speedometer. Severe damage –
including tire disintegration and axle failure – may
result from excessive wheel spinning, causing seri-
ous personal injury.
Goodyear Run-Flat tires are designed for use only on
certain original equipment wheels supplied with a
properly operating low tire pressure-monitoring
system. If applied to a vehicle without a properly
operating low tire pressure monitoring system the
tires may fail when operated in an underinflated
condition, resulting in loss of vehicle control and
possible serious injury or death. Application of
these tires to a vehicle not equipped with specified
operational low tire pressure-monitoring system
constitutes improper and unsafe use of this
product.
Limited Warranty
Who Is Eligible?
You are eligible for the benefits of this Limited Warranty
if you meet all the following criteria:
●
You are the owner or authorized agent of the owner of
new Goodyear Run-Flat (Extended Mobility Technol-
ogy (EMT™) or RunOnFlat™ (ROF) tires and
●
Your tires bear Department of Transportation pre-
scribed tire identification numbers and
(Continued on next page)
32 GOODYEAR RUN-FLAT TIRE LIMITED WARRANTY
To Next Page
Loading...