To Next PageTo Next Page
Need help?Do you have a question about the Infiniti G35 2004 and is the answer not in the manual?
General| Brand | Infiniti |
|---|---|
| Model | G35 2004 |
| Category | Automobile |
| Language | English |
Observe precautions when disassembling and servicing drive shaft for safety and cleanliness.
Lists Kent-Moore tools and their specific applications for drive shaft and wheel hub service procedures.
Details the use of power tools for removing wheel nuts, brake caliper, suspension links, and drive shaft bolts.
Chart to help identify causes of noise, vibration, and harshness symptoms in the driveline/axle.
Check mounting conditions, component status, looseness, wear, and damage of wheel hub components.
Inspect wheel bearing for looseness, noise, and irregular conditions by axial movement and rotation.
Detailed steps for removing and installing wheel hub and related components from the axle.
Inspect suspension arm ball joint for boot breakage, axial looseness, and torque.
Procedures for disassembling and assembling the wheel hub and bearing unit.
Procedures for removing and installing bushings from the axle using suitable drifts.
Inspect wheel hub, axle, and back plate for deformation, cracks, or damage.
Steps for assembling bushings, wheel bearing, back plate, and anchor block onto the axle.
Measure rotating torque and spring scale readings after wheel bearing assembly.
Detailed steps for removing and installing the rear drive shaft from the axle.
General procedures for disassembling and assembling the rear drive shaft components.
Specific steps for disassembling the final drive side of the rear drive shaft.
Steps for disassembling the wheel side of the rear drive shaft, including boot and clips.
Inspect shaft, joint sub-assembly, ball cage, steel ball, and inner race for damage.
Steps for assembling the final drive side of the rear drive shaft, including grease and stopper ring.
Procedures for installing boot and bands on the wheel side drive shaft, including boot length.
Final steps for drive shaft wheel side assembly, including boot and band securement and checks.
Specifications for axial end play, rotating torque, and spring scale measurement for wheel bearings.
Specifications for drive shaft grease quantity and boot installation length for wheel and final drive sides.
Torque specifications for drive shaft side flange and hub lock nut.
