3. Remove part ① and the screws ②. Put them
back to the plastic bag.
Note: Please hold the upper door by hand
during step 3 to prevent door dropping.
1
2
3
1
2
3
Step 3 Step 4
4. Remove the upper door and place it on a
smooth surface with its panel upwards. Loose
screws ③ , detach part ② and part ① , then
install part ① and another part ②(in the plastic
bag)to the left side with screws ③. Put part ②
just detached back to plastic bag.
5. Exchange wire from the right to left slot of
refrigerator body.
6. Loose screws used to fix the middle hinge
and remove middle hinge, Then remove the
lower door.
Step 5 Step 6
-49-
To Next Page
Loading...
