Infiniton SD-8NDP - Page 34

37 inniton.es
How to use
English
Product parts
Due to technological innovations, the product description in this manual may not completely match
your appliance. More detailed information corresponds to the nal product.
Hose holder
Condensation drain hose
Connector
Accesories
The following parts are optional for specic models. If your tumble dryer has the following parts, use glo-
ves to install them according to the instructions below.
1 Power cable
2 Top cover
3 Control panel
4
Water tank
5 Drum
6 Door
7 Door lter
8 Air inlet
9
Filter in base
10 Protective cover
Model SD-8NDP
Drying type Condenser
Product dimensions (height x width x depth) 845 x 595 x 615mm
Maximumloadcapacity(Kg) 8
Rated voltage and frequency 220-240V ~ 50Hz
Ambientoperatingtemperature 5ºC ~ 35ºC
Netweight(Kg) 41
Power 2700W
Numberofprogrammes 9
6
3
8
9
10
1
2
4
5
7
Note
The rated capacity is the maximum capacity of laundry that can be dried at one time. Make sure that
the laundry loaded in the product does not exceed the rated capacity.
Do not install the dryer in a room where there is a risk of frost. At temperatures close to freezing point, the
dryer may not work properly.
There is a risk of damage if condensed water is allowed to freeze in the pump, hoses and/or condensed
water container.