What to do if no hot water is coming out of my Infiniton TEC-50 Water Heater?
If no hot water is coming out, it could be due to several reasons: * The running water supply might be cut off. Wait for the water supply to be restored. * The hydraulic pressure may be too low. Try using the heater again when the hydraulic pressure increases. * The inlet valve of running water might not be open. Ensure that you open the inlet valve.
How to fix a water leak in my Infiniton TEC-50 Water Heater?
If your water heater is leaking, it's likely due to a seal problem in the joints of the pipes. To resolve this, seal up the joints.
Why is the water temperature too high in my Infiniton Water Heater?
If the water temperature is too high, it may be due to failures of the temperature control system. Contact Assistance service helping for repair.
How to fix the heating indicator light when it's off on my Infiniton TEC-50 Water Heater?
If the heating indicator light is off, it may indicate failures of the temperature controller. Contact Assistance Service helping for repair.
General| Capacity | 50 Liters |
|---|---|
| Voltage | 220-240V |
| Temperature Range | 30-75°C |
| Protection | IPX4 |
| Type | Electric |
| Mounting | Wall-mounted |
To Next Page
