NOTE
We recommend that your new washer should to installed by a qualified
appliance technician.If you feel that you have the skills to install the
washer,please read the installation instructions carefully before
installing.
You may need to have the following tools to help you in the installation
of your washer:
Tools needed
Scissors
Gloves
Standard Screwdriver
Pliers
Spanner
Unpacking the washing machine
If your washing machine is not double inlet, you do not have the hot inlet hose.
Unpacking your washing machine and check if is there any damage
during the transportation.Also make sure that all the the items(as
shown below) in the attached bag are received. If there is any damage
to the washing machine during the transportation,or any item is
missing or damaged,please contact the local dealer immediately.
Select the location
Before installing the washer,the location characterized as follows shall
be selected:
-Rigid,dry,and level surface(if not level,please make it lev
el with
reference to the following figure’Adjustable Leg’).
-A
void direct sun light.
-Suf
ficient ventilation.
-The ambient temperature shall be between 0-40℃.
-The ambient humidity shall be below 95%(When the temperature is
25℃).
-Keep far awa
y from the heat resources such as coal or gas.Make sure
that the washer will not stand on power cord.Do not install the w
asher
on the carpet floor.
Install Washing Machine
6
(Connect to Hot
water supply)
Hot Inlet Hose
(Used to plug transit
bolt holes)
Drain Hose
Support Bracket
(Used to loop the end
of drain hose)
Hole Cover (4EA)
Inlet Hose
(Connect to cold
water supply)
Spanner
(1.Used to adjust the bottom
of the machine,
2.Remove the transport bolt on
the back of the machine)
*If washing machine is not double inlet, the machine does not have the hot inlet hose.
To Next Page
Loading...
