Infinity Boss.three 700c - Page 4

SERVICE & TECHNICAL SUPPORT
TOLL FREE 1.855.521.1127
Monday - Friday 8:00 a.m. to 5:00 p.m. Pacific Time
Do not ride a bicycle tha
adjustments may cause irreparable damage to the bicycle and/or bodily
injury
load, nor pedal backwar
the chain and cause serious damage to the bicycle and/or rider.
screw
Chainguide clearance
of 1-3mm
Outer chainguide
Inner
chainguide
Cable
anchor bolt
DERAILLEUR
Although the fron
need to inspect and readjust both before riding the bicycle.
Rear Derailleur
the smallest sprocket. Adjust the High limit screw so the guide pulley and the smallest
sprock
th
qu
ge
will loosen the cable tension and move the chain away from the wheel, while turning
coun
Sh
Low limit scr
are aligned v
gear is achie
cable is adjusted properly.
Ensure all bolts ar
Freewheel
Outer side of top gear
Pulley
adjustment
screw
Adjustment
screws
SIS cable
adjuster
Tension
Pulley
Guide
Pulley
High gear
adjustment
screw
Low gear
adjustment
screw
Barrel
adjuster
FINAL CHECK
may blo
Tighten both front/rear wheel axle nuts or the quick release mechanism securely. Failure to do this may cause the
fron
•
are c
any necessary adjustments.
•
•
•
• Correct maintenance of your bicycle will ensure many years of happy riding. Service your bicycle regularly by referring to the relevant
www.infinitycycleworks.com
copyright 2017 - Infinity Cycle Works Ltd.
FRONT DERAILLEUR
Shi both shiers to the smallest number indicated and place the chain on the
corresponding cog and chainring. Disconnect the front derailleur cable from the cable
anchor bolt. Check the posion of the front derailleur; it should be parallel with the outer
chainring and clear the largest chainring by 1-3mm whenfully engaged. With the chain on
the smallest chainring in front and the largest cog in back, adjust the Low limit screw so
the chain is centered in teh front derailleur cage. Reconnect the cable, pull any slack out,
and ghten the anchor bolt securely. Shi the font shier to the largest chainring. If the
chain does not go onto the largest chainring, turn the high limit screw in 1/4 turn
increments counter-clockwise unl the chain engages the largest chainring. If the chain
falls off the largest chainring, and into the pedals, adjust the HIGH limit screw in 1/4 turn
increments clockwise unl the chain no longer falls off. Shi through every gear, using the
barrel adjusters to fine tune each transion. The barrel adjuster for the front derailleur is
located on the front shier where the cable comes out of the shier. Clockwise loosens
the cable tension and directs the chain closer to the frame, while counter-clockwise
ghtens the cable tension and directs the chain away from the frame.