15
EN
3.3 Hydraulic connection
B - quick connector inlet of water in the panel
C - quick connector Outlet of the water from the
panel
The connection of the PE 4x6 pipe to the quick
connector B and C is very simple. Simply insert the
tube and push upward. (Figure 1_2).
To remove the tube press upward the ring D as in
Figure 3 and pull down the pipe.
Connect the other 2
ends of the PE 4x6 hose
to the 1/2 “ nipples. Un-
screw the nut and purge
the hose through it, then
the hose guard and -
nally push the hose into
the conic connection
rotating until the end.
Screw the nut.
4. Description
To access to the panel unscrew the 4 screws of the gure.
A - speedy pump pH
B - speedy pump Rx
C - sampling tap
D - lighting led
E - box connections
F - Rx probe
G - pH probe
H - plexiglass probeholder
½“nipple
To Next Page
Loading...
