[ Edit: 2016/ 6/ 21 Model: 2017MY INFINITI Q50(V37) OM17E00V37U0 ]
5-32 Starting and driving
cannot be operated. To use Active Lane
Control, set the LDP system to ON. See
“How to enable/disable the LDP system”
(P.5-39).
Active Lane Control settings
GUID-5D2C1649-609C-4F55-9A6B-104397584523
Perform the following steps to set Active
Lane Control.
1. Push the MENU button
*
1
and touch
[Driver Assistance] on the lower dis-
play.
2. Touch [Lane Assist].
3. Enable [Active Lane Control].
4. Touch [Active Lane Control setting] and
select [Low] or [High] to change the
setting of Active Lane Control.
ACTIVE LANE CONTROL LIMITATIONS
GUID-18567D93-57DC-49F8-943B-B3609F61076C
WARNING
Listed below are the limitations for Active
Lane Control. Failure to operate the vehicle
in accordance with these limitations could
result in serious injury or death.
. Active Lane Control is primarily intended
for use on well-developed freeways or
highways. It may not detect the lane
markers for certain roads, weather or
driving conditions.
. Using Active Lane Control under some
conditions of road, lane marker or weath-
er, or if you attempt to change lanes
without using the lane change signal
could lead to an unexpected system
operation. In such conditions, you need
to correct the vehicle’s direction with
your steering operation to avoid acci-
dents.
. Active Lane Control will not operate at
speeds below approximately 45 MPH (70
km/h) or if it cannot detect lane markers.
. Active Lane Control may not operate
properly and should not be used under
the following conditions:
—
During bad weather (rain, fog, snow,
etc.).
—
When driving on slippery roads,
such as on ice or snow, etc.
—
When driving on winding or uneven
roads.
—
When there is a lane closure due to
road repairs.
—
When driving in a makeshift lane.
—
When driving on roads where the
lane width is too narrow.
—
When driving with a tire that is not
within normal tire conditions (for
example, tire wear, low tire pressure,
installation of spare tire, tire chains,
non-standard wheels).
—
When the vehicle is equipped with
non-original steering parts or sus-
pension parts.
. Active Lane Control may or may not
operate properly under the following
conditions:
—
On roads where there are multiple
parallel lane markers; lane markers
that are faded or not painted clearly;
yellow painted lane markers; non-
standard lane markers; or lane mar-
kers covered with water, dirt, snow,
etc.
—
On roads where discontinued lane
markers are still detectable.
—
On roads where there are sharp
curves.
—
On roads where there are sharply
contrasting objects, such as sha-
dows, snow, water, wheel ruts,
Condition:
To Next Page
Loading...