[ Edit: 2016/ 6/ 21 Model: 2017MY INFINITI Q50(V37) OM17E00V37U0 ]
. The radar sensors may not be able to
detect and activate BSI when certain
objects are present such as:
—
Pedestrians, bicycles, animals.
—
Vehicles such as motorcycles, low
height vehicles, or high ground
clearance vehicles.
—
Vehicles remaining in the detection
zone when you accelerate from a
stop.
—
Oncoming vehicles.
—
A vehicle merging into an adjacent
lane at a speed approximately the
same as your vehicle.
—
A vehicle approaching rapidly from
behind.
—
A vehicle which your vehicle over-
takes rapidly.
—
A vehicle that passes through the
detection zone quickly.
. The radar sensor’s detection zone is
designed based on a standard lane
width. When driving in a wider lane, the
radar sensors may not detect vehicles in
an adjacent lane. When driving in a
narrow lane, the radar sensors may
detect vehicles driving two lanes away.
. The radar sensors are designed to ignore
most stationary objects, however ob-
jects such as guardrails, walls, foliage
and parked vehicles may occasionally be
detected. This is a normal operation
condition.
. The camera may not detect lane markers
in the following situations and the BSI
system may not operate properly.
—
On roads where there are multiple
parallel lane markers; lane markers
that are faded or not painted clearly;
yellow painted lane markers; non-
standard lane markers; lane markers
covered with water, dirt, snow, etc.
—
On roads where discontinued lane
markers are still detectable.
—
On roads where there are sharp
curves.
—
On roads where there are sharply
contrasting objects, such as sha-
dows, snow, water, wheel ruts,
seams or lines remaining after road
repairs.
—
On roads where the traveling lane
merges or separates.
—
When the vehicle’s traveling direc-
tion does not align with the lane
markers.
—
When traveling close to the vehicle
in front of you, which obstructs the
lane camera unit detection range.
—
When rain, snow or dirt adheres to
the windshield in front of a lane
camera unit.
—
When the headlights are not bright
due to dirt on the lens or if aiming is
not adjusted properly.
—
When strong light enters a lane
camera unit. (For example: light
directly shines on the front of the
vehicle at sunrise or sunset.)
—
When a sudden change in bright-
ness occurs. (For example: when the
vehicle enters or exits a tunnel or
under a bridge.)
. Do not use the BSI system under the
following conditions because the system
may not function properly.
—
During bad weather. (For example:
rain, fog, snow, etc.)
Starting and driving 5-55
Condition:
To Next Page
Loading...