4. Remove any additional slackfrom the seat
belt;pressdownward
j
3and rearward
j
4
firmly in thecentre ofthe child restraint with
your knee to compressthe vehicle seat cush-
ion and seatbackwhile pullinguponthe seat
belt.
5. Test the child restraint before youplace the
child in it
j
5.Push the child restraint from
side to side and tugitforward to make sure
that it is held securely in place.
6. Checktomakesure that the child restraint is
properlysecured prior to eachuse. Ifthechild
restraint is loose, repeat steps3through 5.
Rear-facing:
Be sure to follow the manufacturer’s instruc-
tionsfor the proper use ofyour child restraint.
Follow these stepstoinstall arear-facing child
restraint on the rear seats using 3-point type
seat belt without automatic locking mode:
1. Position the child restraint on the seat
j
1.
2. Route the seat belt tongue through the child
restraintand insertitinto the buckle
j
2until
youhearand feel the latchengage.
3. To prevent slackinthe seat belt webbing, itis
necessarytosecuretheseatbeltinplacewith
locking devices attached to the child
restraint.
SSS0647AZ
Step 4
SSS0638AZ
Step 5
SSS0759AZ
Step 1
SSS0654AZ
Step 2
SSS0639AZ
Step 4
Safety — seats, seat beltsand supplemental restraint system 1-23
To Next Page
Loading...