What to do if the overheat LED is lit on my Infinium WELD STAR WS-PC40-DV?
If the Overheat LED is lit on your Infinium Welding System, it could be due to the machine being operated beyond its duty cycle. Allow the machine to cool down, and it should reset automatically. Another possible cause is the fan not working; check for any obstructions blocking the fan.
Why doesn't the pilot arc initiate on my Infinium Welding System?
If the pilot arc does not initiate when you activate the torch switch on your Infinium Welding System, it could be due to several reasons. First, check if the air pressure is too low when using an external air supply. Also, worn or missing consumables could be the cause. Ensure that the control option ‘air purge’ mode is set to normal/perforated cutting mode. If these steps don't resolve the issue, the plasma torch may be faulty, and you should have it checked by a qualified technician.
How to fix poor cut quality on Infinium WELD STAR WS-PC40-DV Welding System?
If your Infinium Welding System is cutting but the cut quality is poor, several factors could be responsible. The output current may be set too low. Check for worn consumables or incorrect consumables fitted for the current setting. Additionally, low or excessively high gas pressure/flow can cause this issue.
What to do if the internal air compressor is not functioning on my Infinium WELD STAR WS-PC40-DV?
If the internal air compressor on your Infinium Welding System is not functioning, first verify that the internal/external air switch is correctly set to 'internal'. If an external air compressor line is connected to the machine's inlet air regulator, the system will default to external air, regardless of the switch position; disconnect the external air hose in this case. If the problem persists, there may be a faulty internal compressor or issue with the compressor supply circuitry.
Why is the cutting current low on my Infinium Welding System?
If you're experiencing low cutting current with your Infinium Welding System, start by checking the cutting current setting and adjust it to the correct level. Also, make sure the work return lead clamp is properly connected to the material you are cutting. If these steps do not solve the problem, there may be internal component failures, and you should have the machine inspected by a qualified technician.
What to do if there is no air flow at the torch of my Infinium WELD STAR WS-PC40-DV?
If there is no air flow at the torch of your Infinium Welding System when either the torch trigger is pressed or the air purge switch is activated, examine the compressor (whether internal or external). Check all input air connections and fittings to ensure they are secure. Also, verify the internal connections are not disconnected or loose. Test the air flow by activating the air purge switch to check its functionality.
Why is the cooling fan not working on my Infinium WELD STAR WS-PC40-DV Welding System?
If the primary power switch is on but the cooling fan is not working on your Infinium Welding System, check to ensure the fan is not blocked by any debris. Also, check the fan itself for functionality and verify its power supply.
How to troubleshoot power indicator not lighting up on Infinium Welding System?
If the mains power switch is on, but the power indicator doesn’t light up on your Infinium Welding System, ensure that the input power is turned on. Check the input power fuse, the input cable plug and connectors, and the ON/OFF switch for proper function and continuity.
General| Brand | Infinium |
|---|---|
| Model | WELD STAR WS-PC40-DV |
| Category | Welding System |
| Language | English |
To Next Page
