Need help?Do you have a question about the inform Informer 1000VA and is the answer not in the manual?
General| Capacity | 1000 VA |
|---|---|
| Capacity (Watts) | 600 W |
| Number of Batteries | 1 |
| Output Waveform | Simulated Sine Wave |
| Communication Port | USB |
| Operating Temperature | 0-40°C |
| Frequency | 50/60Hz |
| Battery Type | Sealed Lead Acid |
| Battery Voltage | 12V |
Covers general safety instructions, transport, battery handling, and avoiding fire.
Specific warnings about electric shock and short circuit risks when working on batteries.
Warning about electric shock, not removing covers, and referring to qualified personnel.
Warning to replace fuses with the same rating and install in a controlled environment.
Details the front panel buttons and LED indicators.
Explains the LED indicators for high, normal, and low input voltage.
Describes LEDs for load level and battery capacity.
Details the input cable, output socket, battery socket, and RS232 port.
Inspect the UPS upon receipt and install in a protected area with adequate airflow.
Charge the battery for 4 hours in the initial use for best results.
Plug loads into the UPS output connectors, avoiding laser printers that may overload.
Instructions for turning the UPS on and off using the ON/TEST and OFF buttons.
Use the ON/TEST button to verify UPS operation and battery condition.
Describes BACK-UP, LOW BATTERY, OVERLOAD, and BATTERY REPLACEMENT alarms.
Keep UPS clean, check connections, protect from elements, and operate within temperature limits.
Step-by-step instructions for safely replacing the UPS battery.
Guidelines for storing the UPS and recharging for extended periods.
To Next Page
