Need help?Do you have a question about the infrared industries IR208 and is the answer not in the manual?
General| Brand | infrared industries |
|---|---|
| Model | IR208 |
| Category | Measuring Instruments |
| Language | English |
Connects the analyzer to power and initiates the startup sequence.
Details the setup for automated zeroing using a dedicated zero gas supply.
Describes the components and functions of the analyzer's front panel.
Details the connectors and ports located on the rear panel of the analyzer.
Configures the Zero Solenoid to enable or disable the Zero Port automatically.
Sets low and high alarm values for each measured gas.
Controls the analyzer's internal pump via menu or rear panel switch.
Describes the analyzer's startup phase, including beeps and purging.
Procedure for initiating the zero cycle using Nitrogen, Argon, or Air.
Recommendations for maintaining calibration accuracy every three months.
Explains the need for a regulator to monitor and adjust calibration gas pressure.
Guidance on cleaning the analyzer exterior with specific cautions.
Addresses failure modes like General Failure, Zero Failure, and Failure to Calibrate.
Details the analyzer's warranty terms, exclusions, and limitations of damages.
Specifies what is not covered by the warranty, overriding other implied warranties.
Defines limitations on incidental and consequential damages related to the analyzer's warranty.
To Next Page