Ingco MG1309 - Page 7

7|English
The chart below lists the description, use speed and scope for some of the small articles
supplied together with the tool by category. To achieve best performance of the tool, it is
strongly recommended that you read it prior to operation, failure to adhere to this may
cause accessories to fail.
NOTE!
ALWAYS: Wear eye protection
Insert the shaft FULLY into the collet
Use ONLY up to the speeds stated below
TOOL DESCRIPTION SPEED FOR USE ON:
Grinding Stones
Various head styles,
on shafts
Full speed
30,000/min
Metal
Mild steel
Diamond Bits
Various head styles
Full speed
30,000/min
Wood Zinc
Plastic Nickel
Copper Mild steel
Aluminium Metal
Polishing Wheel
Mounted to polishing wheel
holder (item 14, dia 1)
Half speed
15,000/min
Metal
Mild steel
Sanding/Cutting Discs
Mounted to tool holder
(item 12, dia1)
Note:
DO NOT over tighten screw
Half speed
15,000/min
Metal
Mild steel
Wood
Sanding Drum
Mounted on drum holder
Full speed
30,000/min
Metal
Mild steel
Note:
To fit the drum, firstly loosen the small screw on top of the drum
holder this will allow the rubber to relax. Slide the sanding drum onto
the holder.
To secure, simply tighten the screw and the rubber drum will swell,
gripping the sanding drum.
Use to lock flexible shaft when loosening or tightening collet nut of
flexible shaft.