Ingco MG1309 - MAINTENANCE; Replacing the carbon brushes; Cleaning

6|English
6mm(1/4”)
Switching On and Off
Setting the speed
Holding the tool
ventilation slots.
Note:
t to cover the
MAINTENANCE
Replacing the carbon brushes
The carbon brushes must be checked on a
regular basis. There are two brushes on the tool,
Remove the carbon brush holders, using a
small flat blade screwdriver and check
the brushes.
Note: No spare brush with this tool, if need
call Help line.
Cleaning
Regularly clean the ventilation slots.
of the tool.
Warning!
Slow
Fast
Dia. 8
Note:
Caution
T
l
T
O'.
Many household cleansers contain chemicals that could seriousl
OFF
ON
Dia. 9