7|English
GENERAL SAFETY RULES
△ WARNING: Read and understand all instructions. Failure to follow all instructions listed
bellowed may result in electric shock, tire, and/or serious personal injury.
1. KEEP GUARDS IN PLACE and in working order.
2. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that
keys and adjusting wrenches are removed from tool before turning it on.
3. KEEP WORK ARES CLEAN AND DRY. Cluttered areas and benches invite accidents
Don't use power tools in damp yr wet locations or espore them to rain
4. KEEP CHILDREN AWAY. All visitors should be kept safe di
stance from work area.
5. USE RIGH
T TOOL .Don't force tool or attachment to do a job for which it was not
designed.
6. USE PROPER EXTENSION CORD. Make sure your extension cord is in good condition.
7. WEAR PROPER EXTENSION. Do not wear loose clothing, neckties, rings bracelets, or
other jewelry whitch may get caught in moving parts. Wear protective hair covering to
contain Iong hair.
8. ALWAYS USE SAFETY GLASSES. Also use fact or dust mask if cutting operation is
dusty.
9. DON'T OVERREACH. Keep proper footing and balance at all times.
10. MAINTAIN TOOLS WITH CARE Keep tools sh
arp and clean for best and safest
Performance. Follow instructions for lubricating and changing accessories.
l 1. DISCONNECT TOOLS before servicing, when changing accessories, such as blades, bit,
cutters, and the like.
12. REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure switch is in off
position before plugging in.
13. CHECK DAMAGED PARTS. Before further use of the tool, a guard or other past that is
damaged should be carefully checked and perform its intended function-check for alignment
of moving parts, binding of moving parts, breakage of parts, mounting, and any other
conditions that may affect its operation
14. DO NOT ope
rate tool if you are under the influence of any drugsi alcohol or medication that
could affect your ability use the tool properly
15. NEVER use the power curd to pull the plug out of the pulg out of the electrical socket.
16. ALWAYS keep the power cord aways from sharp objects or any other obstacle that may
cause damage to the cord
SPECIFIC SAFETY RULES
1 Inspect for and remove all nails from lumber before operation. Following this rule will
reduce the risk of serious personal injury.
2. Wear ear protection in continuous working time
3. Make sure the transparent guard secure installed before
operation.
4. When
operation, keep hands away from the rotating parts and hold the trimmer firmly still.
5. Running the tool no loaded for least 1 minute in a protection area when using the new cutter
for the first time.
6. Save these instruction. Refer to them frequently and use them to instruct others who may use
this tool.
To Next Page
Loading...
