What to do if my Ingersoll-Rand Impact Driver motor will not run?
If your Ingersoll-Rand Impact Driver motor will not run: * The motor may be incorrectly assembled. Disassemble the motor, replace any worn or broken parts, and then reassemble it. * There may be insufficient lubricant in the impact mechanism. Lubricate the impact mechanism through the Hammer Case Grease Fitting using the recommended grease.
How to fix Ingersoll-Rand Impact Driver that will not impact?
If your Ingersoll-Rand Impact Driver will not impact, it could be due to: * Broken or worn impact mechanism parts: Remove the Hammer Case Assembly and examine the impact mechanism parts. Replace any worn or broken parts. * Impact mechanism not assembled correctly.
General| Brand | Ingersoll-Rand |
|---|---|
| Model | 2131 Series |
| Category | Impact Driver |
| Language | English |
General guidelines for tool disassembly to prevent damage and ensure proper repair.
Steps for taking apart the impact wrench mechanism, including removing screws and the hammer case.
Detailed procedure for separating the hammers, anvil, and pins from the hammer frame.
Instructions for removing the motor assembly from the housing and cylinder.
Steps for disassembling the throttle control system, including the trigger and inlet bushing.
Procedure for removing the forward/reverse selector buttons and the reverse valve.
General guidelines for reassembling the tool, emphasizing proper lubrication and handling.
Steps for installing the reverse valve, O-rings, and ensuring correct orientation.
Instructions for installing the inlet bushing screen, tilt valve, and related components.
Detailed steps for installing hammers, anvil, and pins into the hammer frame with lubrication.
Procedure for assembling the outer casing, hammer case, and securing it to the motor housing.
To Next Page
