Need help?Do you have a question about the Ingersoll-Rand QX Connect Series and is the answer not in the manual?
General| Brand | Ingersoll-Rand |
|---|---|
| Model | QX Connect Series |
| Category | Power Tool |
| Language | English |
Details the function of the tool's four status LEDs, including color indicators and their meanings.
Outlines the navigation flow for the tool's first use screen upon initial setup.
Illustrates the screen progression and options available in the tool's Basic Mode.
Depicts the screen progression and options available in the tool's Normal Mode.
Guides users on selecting the interface method (App, INSIGHTqcx, PCM, Standalone) upon initial setup.
Instructions for pairing the tool with the INSIGHT Connect App via Bluetooth using a 6-digit code.
Steps to set the INSIGHTqcx controller into pairing mode to establish a connection with the tool.
Describes the limited menu of Basic Mode for quick setting of torque or angle targets.
Details the default password (0000) and procedure to change it via app, controller, or ICS.
Explains how the tool's clock retains date/time during battery swaps and initial setup.
Instructions on how to enter Edit mode and change the target value in Basic Mode.
How to select and edit programmable PSets, including password entry for access.
Guide to editing the Target and Torque High Limit parameters within a selected PSet.
Instructions for editing the Torque Low Limit parameter within a selected PSet.
Guide to editing the Angle High Limit parameter within a selected PSet.
Instructions for editing the Angle Low Limit parameter within a selected PSet.
Procedure to edit the Torque Threshold parameter for counting angle within a PSet.
How to edit the Free Speed setting, which is a percentage of the tool's maximum speed.
Instructions for editing Shift Down Torque and Shift Down Speed parameters.
Guide to editing the Batch Count, which is the number of items to be fastened per group.
Procedure to save or abort changes made to the tool's settings.
Explanation of Ergonomic, Performance, and Productivity modes for tool operation.
How to change between direct drive and ETS modes, and select ETS mode.
Instructions for editing the torque units (e.g., Nm) using arrow buttons.
How to change the fastening direction between clockwise and counterclockwise.
Procedure to change the control method between torque control and angle control.
Describes the target value, primary low limit, and primary high limit display.
Explains the secondary low and high limits for torque or angle values.
Details the Run Screen display, including last fastening result and Batch Count.
Indicates the cycle count since the last reset.
Shows the last fault logged by the tool.
Procedure to edit communication settings (App, INSIGHTqcx, PCM, Standalone).
Steps to switch between Basic and Normal modes, including password entry.
Details fault codes related to Motor Controller, Communication, and Configuration issues.
Lists fault codes for Communication timeouts, Torque/Angle limits, Plausibility, and Battery issues.
Guides on resetting PM alarm cycle counts and time/date occurrences.
Troubleshooting steps for invalid firmware image size, CRC, or ID.
Explanation of tool locked status and how to clear it via Factory Rest.
To Next Page
