EasyManua.ls Logo

Inglesina Moovy - Installation and Fitting Instructions; Installing Seat - Group 0 (<10 kg); Installing Seat - Group I (9-18 kg); Seat Installation Safety Warning

Inglesina Moovy
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
re
n
e
le
o
e
ts
se
ys
a
T
INSTRUCTIONS
FIXING THE SEAT -
GROUP 0 (less than 10 kg)
For children weighing less
than 10 kg, the car seat can
be positioned on the front
passenger seat, only on car with
no airbag there or with airbag
which can be deactivated, or on
a rear seat of the car, but always
facing the rear of the car. The car
seat backrest must be adjusted
into a position with the child laid
as back as possible, according to
the blue dart.
It must be fixed only with adult
3-point safety belt, by running
the lower part of the safety belt
through the base (B) and the
diagonal part of the seat belt
behind the back of the seat, after
running it through the upper
slot (A). Ensure the belt is not
twisted.
IMPORTANT: Check that
the belt is always fully
tightened.
FIXING THE SEAT -
GROUP 1 (from 9 to 18 kg)
For children weighing from 9
to 18 kg, the car seat can be
positioned on the front or rear
seats, facing the front of the car.
It must be fixed only with the
car´s 3-point safety belt, by
running the lower part of the
safety belt through the base
(B) and the diagonal part of the
seat belt behind the back of the
seat, after running it through the
upper slot (A).
IMPORTANT: Check that
the belt is always fully
tightened.
WARNING!
FIXING THE SEAT
GROUP 0 (less than 10 kg)
(Fig. 5) - GROUP 1 (from 9 to
18 kg) (Fig. 6)
You must use the red lock-off
device to block the car´s belt
near the buckle; pay attention to
fix both parts: diagonal and lap
belt (Fig. 5) in the group 0 and
the diagonal belt in the group
1 (Fig. 6)
POSITIONING THE CHILD
AND
ADJUSTING THE BELTS
Position the child on the car seat
and adjust the belts by choosing
the slots in the car seat back that
are most suitable for the child´s
height. The seat belt tension is
adjusted by using the adjuster
running the belt through the
slots on the buckle and on the
seat back. To tighten the seat
belt, push the adjuster upwards
(D) and pull the free end (C).
1
2
3
4
5
6
7
8
UK
English

Related product manuals