04. Warning
1. Please do not disassemble the product if you are not
a professional.
2. Be sure that the sensor is not covered with dust as
dust may lead to inaccurate measurements.
3. Do not use alcohol to clean the sensor.
changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Note: This equipment has been tested and found to
05. FCC Requirement
- 9-
To Next Page
Loading...