1. Coder Dwell is the length of time the
signal to fire the coder in 1/100 sec.
2. Date Coder can be turned on and off,
which is the power for the Coder.
3. The Gap Error and Label Error can be
bypassed of enable, and if enabled uses
the times form the Timer page to produce
the error.
These are duplicate entry fields for the
Main speed from the Main screen and the
Label ratios from the Top Label and
Bottom Label screen.
Recipe Functions
Enter the Recipe number you want to save or
retrieve. Then “Get Recipe” to load the numbers
into the PLC. “Save Recipe” will store the current
active numbers in the PLC into that recipe
number. Keep in mind that the active numbers
stay in the PLC despite the recipe number
changing back to “1” through a power cycle.
To Next Page
Loading...