INNO Cargo Box User Manual

5735-70195
1
2
3
5
6
8
These instructions are for the installation and use of the Inno carrier system attachment. After reading this manual, keep it in a safe place along with the
installation instructions for the rest of your carrier system.If you have any questions regarding the information in this manual, please contact the service
center listed at the end.
IN
IN55
If using an aftermarket base rack system, make sure that it is installed properly
according to the procedures described in the installation instructions for that rack.
The distance between the front and rear crossbars should be at least 60cm ( 2 feet )
Cargo Box Installation Instructions
Cargo Box Installation Instructions
CAUTION
PRECAUTIONS
Do not overload your cargo box. Maximum load
capacity varies by vehicle. Check the appropriate
lim
its for your car in the Fit Guide and your vehicle
own
er's manual and determine your maximum
loa
ding capacity with the formula below.
The Cargo box includes the parts listed below. Verify that they are included with the
carrier you have purchased. In the event any of these is missing, contact our service
center as listed at the end of this manual.
4
7
Before driving the vehicle, shake the rack in
all directions to ensure that there is no
loo
seness in any of the mounting knobs and
scr
ews. Retighten any loose knobs or screws.
Max load of
car
go box
110 lbs
Max load of
vehicle or
cro
ss bar
Weight of
car
go box
OR
-
noitallatsnI
noitcurtsnI s
Use the lower of the 2 options below
Parts
Rooftop Box
QtyNO.
Knob
U-Bolt
Plate
Strap
Hole Covering
Molding
1
8
4
4
2
Strap Hook 2
2
Key
Manual Instruction
2
1
6
Temporarily put the Box on cross bars. And Insert key, turn clockwise and
push button to open the Box.
Adjust the location of the Box to align with holes at A.
Rooftop Box
Cross Bar
A B
Front
Attach the Box to front cross bar with Plate, U-Bolt and Knobs. Make sure that
the ring on the Plate is on the side nearest the side of box.
U-Bolt
Ring
Plate
Cross Bar
Front
Ring
Plate
Cross Bar
Rear
U-Bolt
Tighten right and left knobs alternately to secure the Box to cross bar.
U-Bolt
Knob
Front
U-Bolt
Knobs
Rear
Make sure to tighten the right
and left knobs evenly so that
the U-bolt sits square with the
bar.
If U-bolt is not tightened
correctly, it may allow the box
to come loose.
Warning
U-Bolt
Cargo Box
Cross Bar
Front - Place plugs into the 6 unused holes to seal
Rear - Trim Molding to the proper size and insert into slot.
U-Bolt
Plug
Front
U-Bolt
Cut Molding to this size.
Molding
Rear
Thread Strap trough two Rings on each side of the box and
fasten. Attach Strap Hooks inside box lid just above Straps.
Push Box in all directions to make sure that there is no
loosenesss. If you notice any play in the box, retighten 8 Knobs.

INNO Cargo Box Specifications

General

Category	Automobile Accessories
Type	Cargo Box
Material	ABS Plastic
Color	Black
Compatibility	Universal roof rack systems