INNOLIVING INN-721 - Page 15

15
GB
2. If you notice that the device works with effort, remove half of the dough from the bowl
and work each part separately.
3. The ingredients mix best if you pour the liquid rst.
Cleaning
1. Turn off and unplug the appliance, allow the device to cool down before cleaning.
2. Do not immerse the main unit in water and make sure no water enters.
3. Clean the main unit with a soft damp cloth.
4. Do not use brushes, steel wool or solvents to clean the unit as they could damage it.
5. Remove accessories from the mixer and wash them separately. Clean all the accessories with
a mild detergent.
6. Dry all parts thoroughly before using again.
7. Cover the sides with a protective lm after being washed and dried thoroughly.
Blender Jug
• Remove the cap from the main unit by pushing the button on the back, see Fig.1.
• Put food in the blender, close tightly the lid and place it directly on the main unit.
• Turn the blender clockwise to secure it to the base.
• Connect the appliance to the power outlet and select the speed setting desired.
• You can add liquid components (eg. Oil, cream or other) while the blender is in operation by
using the appropriate opening in the upper part. Turn the cap clockwise to remove.
• Once you have nished processing, set the speed 0 and disconnect the device from the
power outlet. Attention: Big pieces food needs to be cut into small pieces (more or less
2cmx2cmx2cm)
g.1
Mixing Bowl
1.Chopping Function
• Remove the cover from the main unit, turning it counterclockwise.
• Insert the turn axis onto the body tightly see g 2.
• Place the chopper on the axis turning it clockwise to secure the unit.
• Insert the blades at the center of the plastic bowl.
• Insert the food inside the bowl, taking care to cut it into cubes before.
• Place the lid on the bowl by turning it clockwise.
• Insert the plug into the socket, select the desired processing speed (speed increases
according to the level selected. PULSE is the highest level. Select the speed pulse at intervals)
• After processing, select the speed 0 and remove the food from the bowl, making sure that
the blades have stopped.