Page 9 HRA-I SLIM MANUAL
1.9 PACKAGING AND TRANSPORT
The units are handed to the forwarder secured to a wooden pallet and inserted in cardboard boxes. To facilitate shifting operations,
the units have a wooden pallet and fastening devices on the base for lifting and positioning the unit in its installation site. The unit
can be stored in a room protected against atmospheric elements at temperatures not below 0°C and up to maximum 40°C.
1.10 RECEPTION, INSPECTION AND HANDLING
The unit is shipped completely pre-charged with refrigerant gas in the circuits and non-freezing oil in the compressors. In no case
can there be water in the hydraulic circuits, as the unit is thoroughly emptied after the testing phase. Upon the unit’s arrival, the
customer must inspect also the internal zones to verify that no damage was caused during transport; the unit leaves the factory in
perfect condition. If damages are found, the transporter must be informed immediately by reporting in detail the entity of the
damage on the delivery note, producing photographic evidence of the apparent damage and notifying the apparent damage to the
forwarder via registered letter with return receipt requested. The manufacturer shall not be held liable for transport-related damages
even if the manufacturer itself shipped the product. The unit must be handled very carefully during its unloading and positioning on-
site, so as to avoid damaging the casing and the more delicate internal components such as the compressors, heat exchangers, etc.
At all events, keep the unit positioned horizontally without tilting it. All indications regarding the precautions to be applied for
preventing damages to the unit and the indication of the weight of the unit itself also appear on the packaging. The packaging can
have various types of constituent materials, including wood, cardboard or polyethylene (plastic). It is good practice to send them to
the waste disposal facility or recycling centre through specialised companies in order to reduce their environmental impact.
1.11 DISMANTLING AND DISPOSAL
Do not dismantle or dispose of the product autonomously. The dismantling, demolition and disposal of the product must be carried
out by authorised personnel in conformity to the local regulations.
To Next Page