Need help?Do you have a question about the Innova K02R2Y and is the answer not in the manual?
General| Brand | Innova |
|---|---|
| Model | K02R2Y |
| Category | Indoor Furnishing |
| Language | English |
Use an electrical surge protection device to protect your investment from power surges or outages.
Do not open or tamper with the transformer, control box, motors, or remote control, as it voids the warranty.
Dispose of packing materials promptly. Do not allow children or pets under the bed.
Adjustable beds are for home comfort, not hospital use or for patients needing bed rails.
Covers defects in workmanship and materials for one year. Innova covers parts, labor, and transport.
Covers defective parts for two years. Purchaser pays for service and transport costs; defective part must be returned.
Covers mechanical bed base parts for 20 years. Purchaser pays for service and transport costs after first year.
Bed lift motors are not designed for continuous use over 2 minutes in an 18-minute period (10% duty cycle).
The adjustable bed has a 950 lbs limit, evenly distributed. Exceeding limits may cause damage or injury.
A minimal humming sound during operation of the lifting and lowering feature is normal.
General safety advice to reduce risks of shock, burns, fire, or injury.
Instructions for setting and using memory buttons (P1, P2) for custom bed positions.
Press the Flat button to return the bed to a flat position.
Use the Flash Light button to turn the flashlight on and off.
The battery backup returns the base to flat position during a power outage. Install two 9V batteries.
Details on how to use one remote to control two side-by-side beds for Eastern King or Cal-King setup.
Instructions on how to copy settings from a master remote to a new remote for dual control.
Procedure to remove a cloned remote from controlling the bed base.
Check and verify all parts are included before discarding any packing materials.
Connect the Transformer to the Control Box using the provided power cord.
Insert batteries into the wireless remote and perform initial button tests.
Match the remote control with the control box using the reset button.
Firmly screw the six legs into the threaded holes in each corner of the base frame.
Remove, turn upright, and reinstall the mattress retaining bar, securing it with clips.
To Next Page