REV. 01/30/2020 PN: PG:1
2257 route 139
Drummondville, Québec
J2A 2G2
1 year on step and closure.
1 year on hardware.
MANUFACTURER WARRANTY
WWW.INNOVAPLAS.COM
WARNING
Install the step on a flat surface.
Do not jump or dive from the step or ladder.
Remove the step from water when temperatures drop below freezing.
In winter, the step should be stored in an area protected from snow.
Never lift the step by its handrails.
Use BATTERY operated tools to avoid electric shock near water.
Ensure no corrosive materials are added to the step or harware kit.
The step must be installed per manufacturer’s instructions.
File off all stripped or sharp edges before assembly to avoid injuries
and liner damage.
The manufacturer is not responsible for damages or injuries caused
by improper installation or use of product.
To ease the installation of handrails and bolts, use a screwdriver to
line up the holes.
Required tools
(not included)
A
2X
GUSSET
INSERT NUT
1) Insert the two gussets in the slots and slide them
toward the corners.
2) Assemble the two main modules with the six screws,
nuts and washers provided.
3) Snap the door between the top and bottom module
within the slots provided.
Sand
(not included)
Sand
15 lbs
x6
x6
x6
A B C
Phillips #2
Phillips #3
7/16 wrench
Phillips bit
BILTMOR 5015 WITH SELF-LATCHING 9600
Sand
15 lbs
Contents of the Biltmor box SKU # 5015
Contents of the Self-Latching box SKU # 9600
MAXIMUM functional
width is 1/4’’.
A weather-resistant
padlock is recommended
(not included).
Security strap
x2
x2
x2
(3/4 IN.)
x12
(2 1/2 IN.)
x2
SCREW KIT 140-0016
(2 1/2 IN.)
F
G D C
x2
x4
x3
SCREW BAG 140-0036
x6 x6 x6
(1 IN.)
(³⁄4 IN.)
x2
(³⁄4 IN.)
x13
A
B C D E
x2
x2
x3
x2
x2
To Next Page
Need help?
General
