Need help?Do you have a question about the Innoveco Glass Chiller and is the answer not in the manual?
Ensure CO2 tank has a tube to the bottom for optimal performance.
Mount the gas hood onto the chiller machine.
Insert 2 AA batteries into the machine's top compartment for the LED light.
Secure the machine on a desk or bar counter with thickness between 15mm and 80mm.
Connect the CO2 cylinder valve to the chiller unit using fittings and safety wire.
Turn on the CO2 tank and activate the chiller machine to begin cooling.
Shut off the valve on the CO2 cylinder before proceeding.
Release residual pressure from the chiller by pressing its switch.
Loosen the connection fitting between the unit and the cylinder.
Attach the chiller unit to a new CO2 cylinder following initial setup procedures.
To Next Page
General