EasyManua.ls Logo

Inofia HD161A - Timer Setting

Inofia HD161A
18 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
Step 2: To turn the dehumidifier on, press the POWER button. The dehumidifier will run
in the default setting of 30% set humidity. And the LCD will display the ambient humidity.
Step 3: If you want to set a desired humidity, press the HUMIDITY button continuously
to choose a value between 30%-80% in increment of 5%. After you have set the desired
humidity, the readout will display the actual room humidity in a few seconds.
Step 4: You can also use the FAN SPEED button to change the fan speed to HIGH or LOW.
The indicator light will show the setting you have selected. A higher fan speed will result
in quicker moisture removal.
Step 5: To shut the dehumidifier down, press the POWER button again.
4. Timer Setting
The TIMER function enables you to either Delay Start or Delay Stop the dehumidifier in
the choice from 1 hour to 24 hours. If the dehumidifier is running, then selecting Timer
will turn the dehumidifier off in the hours that will be set (Delay Stop). If the
dehumidifier is off, then selecting Timer will turn the dehumidifier on in the hours that
will be set (Delay Start).
1) Once plug it in, the control panel will be light up for a second and then turns off. Youll
need to press the POWER Button to turn the dehumidifiers on.
2) If the FULL light is on, remove the bucket and re-install it properly.
1) The set humidity needs to be at least 10% lower than the ambient humidity.
2) If at any time you want to return to the CONTINUOUS Mode, pressing the
HUMIDITY button will lower the Relative Humidity through the 5% increments until
the display reads 30.

Other manuals for Inofia HD161A