Inomatic AMTEK 450 - Page 4

AMTEK Version 7.4 2019-01 Page 4 ©Inomatic 2017-2019
Typical System Performance
Depending on the AM tags used and the installation environment, the detection distance
can vary. The following table gives an overview of typical detection ranges with the
different AMTEK systems and security elements.
Distances(m)
AMTEK 350 Mono
AMTEK 350TX/RX
F40 tag
1.40
2.70
Mini Pencil
1.20
2.20
Super tag II
1.10
2.00
DR label
1.10
2.00
1.2. Additional Features
All Version AMTEK V7.4 Processor antennas are equipped with 2 additional alarms that
allow an easier handling of certain situations.
The Jammer alarm indicated that the system is compromised by a jammer signal.
The alarm light and buzzer sequence for Jammer alarm can be set via InfoNet software.
In this case the detection of the system is disabled to avoid false alarm.
The Near Tag alarm is triggered by a continuous detection of a stationary security
element in the detection zone. The alarm light and buzzer sequence for Jammer alarm
can be set via InfoNet software. By enabling the Near Tag alarm, one can easily detect
tags that have accidentally been placed inside the system’s detection area.
Both of the above described alarm features can easily be enabled/disabled by activating
the respective checkbox inside the InfoNet software.
Programmable on/off time:
The system can be automatically switched on/off at certain times. The time for ON and
OFF can be set via the InfoNet software. The system will consume much less power during
OFF time (Energy saving)