Inovance MS1H4-40B30CB - Page 22

1 Product Information
- 21 -
Table 1-14 Cables for terminal-type (Z series) motors with rear cable outlets (drag chain)
Cable Type
Cable Length (m)
3.0 5.0 10.0
Power cable (without brake) S6-L-M108-3.0-T S6-L-M108-5.0-T S6-L-M108-10.0-T
Power cable (with brake) S6-L-B108-3.0-T S6-L-B108-5.0-T S6-L-B108-10.0-T
Absolute encoder cable S6-L-P125-3.0-T S6-L-P125-5.0-T S6-L-P125-10.0-T
Incremental encoder cable S6-L-P115-3.0-T S6-L-P115-5.0-T S6-L-P115-10.0-T
Table 1-15 Cables for lead wire-type (Z-S series) motors (drag chain)
Cable Type
Cable Length (m)
3.0 5.0 10.0
Power cable (without brake) S6-L-M100-3.0-T S6-L-M100-5.0-T S6-L-M100-10.0-T
Power cable (with brake) S6-L-B100-3.0-T S6-L-B100-5.0-T S6-L-B100-10.0-T
Absolute encoder cable S6-L-P120-3.0-T S6-L-P120-5.0-T S6-L-P120-10.0-T
Incremental encoder cable S6-L-P110-3.0-T S6-L-P110-5.0-T S6-L-P110-10.0-T
NOTE
◆
The cables matching SV820N servo drives are re-named from SV82-L-** to S6-L-
**.
◆
The term "drag chain" in the table title means the cables used in the moving
parts such as manipulators must be 󶍿exible cables applicable to drag chains.
◆
Terminal-type motor encoder cables shorter than 25 m require no adapter
cables.
Speci󶍾cation for cables between 10 m to 25 m: 1Px22AWG+2Px26AWG
Speci󶍾cation for cables shorter than 10 m: 3Px26AWG
◆
The S6-C24 cable kit is required for terminal-type motor encoder cables longer
than 25 m. Contact Inovance sales sta󶍽 for details on the cable length.
◆
Speci󶍾cations of swinging-type motor encoder cables:
10 m to 25 m: 1Px22AWG+2Px26AWG
below 10 m: 3Px26AWG
◆
Contact our sales staff for purchasing swinging-type motor encoder cables
longer than 25 m.