To Next PageTo Next Page
Need help?Do you have a question about the Inside Out Networks Wavespeed/S and is the answer not in the manual?
Power| power input | 5 V |
|---|
Ports & interfaces| 3-position switch modes | ON/OFF/CONFIG |
|---|---|
| female DB-9 connector | Yes |
| baud rate | 300, 1200, 2400, 4800, 7200, 9600, 19200, 38400, 57600, 115200 |
Guides users through the process of setting up the Wavespeed/S device for operation.
Details the steps for configuring the device to replace a serial cable wirelessly.
Explains how to detect and pair Wavespeed/S devices for wireless communication.
Specifies the serial port emulation settings for the local Wavespeed/S device.
Provides information on the status indicators for the device's green LED.
Details the pin assignments for the DTE and DCE serial connectors.
Guides the configuration of serial port settings for the remote Wavespeed/S device.
Explains how to configure the device to act as a Serial Port Profile server.
Sets up the serial port emulation and communication parameters for the local device.
Describes the process for updating the device's firmware.
Provides technical details including power, switch, connector, and port settings.
